See Details on eBay

24Ft 3" X 8Ft 6" Apex Concrete Sectional Garage/garage Tel 07850876904

£2,399.00 or Best Offer Unsold, FREE Shipping, 14-Day Returns

Seller: chapmansectional (333) 100%, Location: Scunthorpe, Ships to: GB, Item: 152784710007 24FT3" X 10FT6" APEX ONLY £2399.00 & TIMBER SIDE DOOR + £100.00 PLEASE DO NOT BUY IT NOW THIS PRICE FOR UP TO 40 MILES FROM OUR SITE PLEASE RING FOR OTHER AREAS Many customers prefer the appearance of a pitched roof and to compliment our Pent buildings we offer the Apex range. With improved drainage qualities and greater strength this roof offers a wider choice of sizes. 16FT 3" X 8FT 6" APEX CONCRETE SECTIONAL GARAGE NOW £1499.OO WITH 7FT HORMANN FULLY RETRACTABLE STEEL UP & OVER DOOR & 1,4FT WINDOW.TIMBER SIDE DOOR CAN BE ADDED FOR AN EXTRA £100.00 ALL SIZES AVAILABLE 10 YEAR STRUCTURAL GUARANTEE ON ALL GARAGES & 10 YEARS WARRANTY ON ALL HORMANN DOORS DELIVERED & ERECTED FREE UP TO THIRTY MILES FROM OUR SITE PLEASE RING FOR OTHER AREAS WE DO NOT DELIVER AS FAR AS LONDON OR SCOTLAND 1. The base should be flat & level over foot print of garage / building. 2. A 3” trowelled or floated edge to the base should be provided all the way around the base to ensure that there is a slight fall away from the foot print of the building, 3mm or 1/8th of an inch is ideal. This will encourage rain water to run away from the building.3. The base should be at a slightly higher level to that of the surrounding area making sure that water cannot easily penetrate the new buildings walls.4. The base should be only 3” larger than the external dimensions of the building. If the base is any larger than this water could sit on the base and this could lead to water penetration.5. Where a ramp is added to the front of the base make sure this does not end up with a slightly higher level than that of the main base as this will encourage water to enter under the up and over door. The ramp should obviously always be sloping away at a lower level than that of the main base.6. If an old existing base is to be used it is unlikely that it will comply with all of the above and consideration should be given to resurfacing the existing base in order that it does comply. A sand and cement fillet is often applied round the base of the inside of the garage to help seal it. Again, if the base is not laid correctly the fillet’s integrity will be compromised and it is possible that water could ingress into the garage.Our nationwide network of agents can provide further advice on garage bases and most will come out and do a free site survey for you if required. The Apex roofs have 70 x 70mm planed and treated wooden purlins fastened to primed and fabricated steel trusses with fibre cement asbestos free (non- With many options available to personalise your building please do not hesitate to ask your agent for help and friendly advice to ensure you receive the specification to suit your requirements. The Apex uPVC To compliment our Apex range, we also offer the Apex uPVC. A virtually maintenance free building, which will retain its stunning good looks with an occasional wipe clean. This stylish and modern garage will compliment and add value to almost any property. • All external fascias are uPVC clad white. • Dark Brown or Golden Oak is available on request. Bases, Delivery & Erection Concrete Base Requirements Garages should only be erected upon a permanent concrete base of suitable thickness. We recommend a minimum of 4 inch thickness throughout. The base should be FLAT, LEVEL AND SQUARE, and at least 6 inch longer and 6 inch wider than the external dimensions of the garage to be supplied. General The ground surrounding the base should be lower than the base. If not, water will lay on the base and break through the sand and cement fillet and leak into your building. If the driveway slopes down towards the front of your building, you must put in a gulley to take any surface water away. We cannot guarantee the performance of your building unless a gulley has been fitted. In order to check that your base will be laid square, measure out a 3-4-5 triangle as per adjacent sketch before securing your timber shutters. In order to give your timbers a final check prior to concreting, measure the diagonals which should be equal. We would also advise you to use a reputable ready-mix concrete company who will also be able to tell you the amount of concrete required. If you are close to an existing building or boundary wall, make sure that you allow for the overhang of the roof, i.e., flat roof garages 6 inch (150mm) on front and rear and 3 inch (75mm) both sides, apex roof 6 inch (150mm) front, rear and both sides. This does not include gutter width. After your garage has been erected we strongly recommend that a sand & cement fillet be placed on the base to panel joint all around the inside (not outside) of the building to avoid ingress of water. We recommend a 3 part building sand to 1 part cement with Unibond (PVA) added to the mix Your concrete base must be LEVEL from front to back and side to side. If the base slopes from side to side, e.g. left to right, there will be problems sealing the end wall of the garage, fixing the roof, and the door will not fit evenly at the bottom when it shuts. The Base must be FLAT - if it has bumps in it the panels won’t join up properly or the roof won’t fit. The base must not slope or the panel bolt holes will not line up and the roof may leak. Delivery & Erection Your building will be delivered, erected by one of our own trained installation teams, professional, expert in what they do, working together, using their experience... something we have built our reputation on! Should we not be able to erect a building at the time of delivery it will be either off loaded on site or returned to our production plant and a further revisit charge made before we re-erect. Most of our vehicles are 24 tonne - equivalent size to a single decker bus, if you suspect a problem with this size lorry, e.g. low bridges, weight limits, width restrictions etc., please let your agent know and we will try and make alternative arrangements. Our forktrucks require a minimum width of 8ft to operate. If you do not have this distance then simply inform your agent so that other delivery arrangements can be made. We have wheeled trolleys that can access most areas to facilitate your building installation Condition: New

PicClick Insights PicClick Exclusive
  •  Popularity - 90 views, 2.7 views per day, 33 days on eBay. High amount of views. 0 Sold, 1 Available.
  •  Price -
  •  Seller - Over 333 items sold. 0% negative feedback. Great seller with very good positive feedback and over 50 ratings.
People Also Loved