MDPE Plastic Compression Water Pipe Fittings Sizes: 20mm-25mm-32mm 1/2"-1" BSP

The professionals choice for MDPE Compression fittings for MDPE & PE pipe

WRAS approved for use with potable water

Any water fitting, which when installed, will carry or receive 

water from the public mains water supply in the UK, 

must comply with the Water Supply (Water Fittings) 

Regulations or Scottish Byelaws.  These require

 that a water fitting should not cause waste, misuse, 

undue consumption or contamination of the water supply 

and must be ‘of an appropriate quality and standard’. 

WRAS Approval is the easiest way to demonstrate

 compliance as it is granted directly by representatives

 of the water suppliers and is therefore

 accepted by every water supplier in the UK.

WRAS Product Approval: Whole products such as valves,

 fittings, boilers & showers undergo mechanical 

and water quality testing. This type of approval demonstrates

 full compliance with requirements of the regulations and byelaws, 

provided the fitting is installed according to any conditions given with the approval.

WRAS Material Approval: Non-metallic materials & components,

 such as rubber sheet material & ‘O’ rings, undergo testing

 only for their effects on water quality.  This type of approval

 demonstrates that the non-metallic material/component 

does not itself contaminate the water and therefore

 satisfies this particular requirement of regulations and byelaws