Seller:craigie_hill✉️(7,270)96.7%,
Location:ShenZhen, CN,
Ships to: EUROPE, US, CA, AU,
Item:295242967676Laminator Laminating Machine A4 A4/A5/A6 Plastic Film/Corner Rounder/Hole Punch.
Product name: Portable A4 Laminating Machine Small Household Laminating Machine Photo Laminating Machine Photo Laminating Machine
Feature: 1. A4 and backward compatible, support various sizes of plastic sealing / low noise and quieter / 1-2min fast preheating / 320mm/min plastic sealing is more efficient / 115~145 ℃ intelligent temperature control without adjustment / ABS one-click film release and card release pause. 2. More than just photos, to meet different needs, suitable for photos/menu/documents/certificates/drawings, etc... a variety of paper documents. 3. Support a variety of sizes, meet various conventional sizes of A4 and below, A4/A5/A6/6 inches/5 inches/4 inches/3 inches 4. The over-plastic efficiency is as high as 320mm/min, which is faster and more efficient, saving time and cost. 5. The ABS film can be released with one key. If there is a jam in the plastic seal, you can easily push the film by pressing the ABS film release button. 6. Various accessories can be matched and selected, each size of plastic film / hole punch / fillet knife / cutter ruler, one-stop service / optional.
Specification: Product size: 32*10*6cm Overmolding width: 230mm (A4) Plastic thickness: 60~100mic Plastic package size: A4 (any size below) Overmolding speed: 320mm/min Heating method: Quartz heating wire Preheating time: 1~2min Constant temperature range: 115~145℃ Film removal method: ABS toggle one key to remove film Power supply: ≈300W Power supply voltage: AC220V-240V (US standard AC110V-120V )
Common problems and corresponding operations of plastic sealing
Cloudy white spots appear 1 The temperature fails to reach the set point: wait for the melter to reach the undetermined temperature before it can be used 2 The temperature setting is not enough: set the temperature to the temperature required by the corresponding thickness bubble point: 1. High temperature: appropriately lower the temperature 2 There are impurities in the rubber roller of the glue machine: clean the impurities on the rubber roller Over-glue wrinkle and uneven 1. The temperature is too high: adjust the temperature appropriately 2. The rubber roller of the glue machine is not flat: check whether the rubber roller is flat and intact 3 When the glued object is placed, it is not flat: the glued object is placed flat and then placed in the plastic sealing machine. Foggy white spots on non-stick paper and photos 1. The temperature is too low: increase the temperature appropriately The photo is not sticky on all sides or the edges are blistered 1. The pressure of the rubber roller of the glue machine is not enough: adjust the pressure of the rubber roller of the glue machine 2 The temperature is not enough: increase the temperature
Packing list: 1*Laminating machine 1*Manual 20PCS Set Include: 5PCS A4 plastic film 5PCS A5 plastic film 5PCS A6 plastic film 1PC Corner rounder 1PC hole punch 1PC Ruler cutter 1PCManual